Revo REVDPTZ22-2 Manual de instrucciones descargar pdf (Pagina 28)

ALARM OUT SETUP

OUT : ALARM

EXIT(ESC TO EXIT)

ALARM: alarm output is operated during an alarm operation or by the short key of our

keyboard.

1-5 MIN(minute): alarm output is operated during this setting time only by the function run of

the dome menu or the short key of our keyboard.

NOTE: This 1-5 MIN setting is not operated by an alarm.

3.10 Area Title

Enter a specific name on programmed angle between START and END. For the screen below,

when the camera points at an angle between 124.3° (PAN), 30.7° (TILT) to 359.5° (PAN), 45.4°

(TILT), ABC will be displayed on the screen.

AREA TITLE SETUP

NUMBER : 01

TITLE : ABC

START ANGLE : 124.3 30.7

END ANGLE : 359.5 45.4

SWAP : OFF

SAVE AND EXIT(ESC TO CANCEL)

NUMBER : 01-08

TITLE : up to 12 characters.

SWAP : Swap the start point for the end point.

1. Select “NUMBER” and set the desired number by pushing the Joystick to the left or right.

2. To edit the title, follow the procedure of the Auto Scan above to edit titles.

3. Select “START ANGLE”. Hold down the CTRL key while selecting the start position using the

Joystick. Current panning position will be displayed. Release the CTRL key to complete the

selection of the start position. Or press the IRIS Open key then the “CTRL” displays. Move the

desired position. Press the IRIS Close key then the “CTRL” disappears. To adjust at the 0.1

degree interval, twist the Joystick at the pan field and the tilt field.

4. Select “END ANGLE”. Hold down the CTRL key while moving the Joystick to select the end

position. Release the CTRL key to complete the selection of the end position. Or press the

IRIS Open key then the “CTRL” displays. Move the desired position. Press the IRIS Close key

then the “CTRL” disappears. To adjust at the 0.1 degree interval, twist the Joystick at the pan

field and the tilt field.

5. Select “SWAP”. Set to ON, to exchange the start angle and the end angle.

6. Select “SAVE & EXIT” and push the Joystick to the right or press the IRIS Open key. Press

the ESC or IRIS Close key to exit the program without saving.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sin comentarios

Revo REVDPTZ22-2 Manual de instrucciones Pagina 28