Revo REVDPTZ22-2 Manual de instrucciones descargar pdf (Pagina 27)

2. Select the desired Pattern to be programmed by pushing the Joystick up or down. If the

Pattern is not 000, a Pattern has already been recorded. Patterns can be overwritten.

3. Press and hold down the CTRL key while controlling the camera direction and zoom with the

Joystick. The dome will be automatically recorded until you release the CTRL key. Or press

the IRIS Open key then the “CTRL” displays. Move the position and the zoom position.

Press the IRIS Close key then the “CTRL” disappears.

4. Select “SAVE & EXIT” and push the Joystick to the right or press the IRIS Open key. Press

the ESC or IRIS Close key to exit the program without saving.

5. To edit the title, follow the procedure of the Auto Scan above to edit titles.

NOTE: Press the HOME key at any programmed position to delete the Pattern.

NOTE: If Pattern recording time reaches 200 seconds, it will automatically stop for a

moment.

PATTERN AREA SETUP

(CTRL KEY)

NUMBER 01

000 00.0%

001 01.0%

EXIT(ESC TO EXIT)

Press the PTRN key on the title field to display with the small OSD. Then the screen will show as

below.

The setting procedure is the same as above.

3.9 Alarm

ALARM SETUP

NO PRI FUN IN OUT HLD LATCH

01 1 001 NC ON 03 OFF

ALARM OUT SETUP

SAVE AND EXIT(ESC TO CANCEL)

NO : alarm input number

PRI(Priority) : The lower number has higher priority. (1 fixed)

FUN(Function) : Stored function number to be called by alarm.

IN : NO/NC - normally open/closed, OFF - ignore

OUT : ON – TTL output on, OFF – No output.

HLD(Hold) : Alarm will be held for programmed time (03 to 99 seconds)

LATCH : ON – Alarm message will remain on the screen even though alarm input

is deactivated.

OFF – Alarm message will disappear on the screen after programmed

hold time when alarm input is deactivated.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Sin comentarios

Revo REVDPTZ22-2 Manual de instrucciones Pagina 27