Revo REVDN700E-2 Manual de instrucciones

INSTRUCTION MANUAL INDOOR-DOME Super High Resolution Day & Night Color Camera (Optional WDR) VP-DOMEREVDN700E-2

INSTALLATION – VP DOME 1. Loosen the four torx screws located midway up the front of the housing leaving the screws intact in the front portion. (Fig.

INSTALLATION – INDOOR DOME 1. Using the drilling guide, drill the mounting holes and cable hole in place on the ceiling or wall. 2. To remove dome c

LENS ADJUSTMENT Field of view: Adjust setting from Telephoto (T) to wide (W) field of View. Focus: Adjust lens focus from near (N) to infin

CAMERA OVERVIEW External AD Key Control (optional) F. Test Video Output G. External AD Key Input H. BNC/UTP Switch A. Up B. Right C. D

Editing Area(No Save), Default(Read Only). Save Area(Use on Start), Backup * Don’t Power off while doing Save, Load, Backup, Overwrite CAMERA ADJUSTME

* Motion is occured: Fast screen update mode. 3) Low Light: If using UDF function, this function being disabled. - AGC: Boost the signal and adjustin

Global Functions: This functions being performed in the entire area. - Output Select: It must be specify the outputs, each function will be enabled. P

* For more than 180 of interior angle is not permitted. Line: Select Start/End Point. It you select one of start/end, the active point is displayed.

recording start. *) In Simple mode is not supported. In & Out Direction Rect Detect object moving. From top to enter of area, detecting dire

Rst Time (sec): Time for release to windy object that staying with no motion 3) Display Setup: Configuration for information on screen. NOTE: * Prior

LIMITATION OF LIABILITY THE INFORMATION IN THIS PUBLICATION IS BELIEVED TO BE ACCURATE IN ALL RESPECTS, HOWEVER, WE CA

- Cam Info: Display camera basic information. NOTE: * Cam ID/Baud rate/Protocol/Lens Type/CCD Type/Video System/Firmware Version - System Lock: Syst

Automated white pixel compensation for not compensated pixel by static method, No limits of compensation pixel number. Select level (Low/M

Active only used AC Power. - Int(Internal)/Ext(External) If mode is set to Ext, Sync Phase can be adjusted. 5) Day/Night - Detection: Configur

EXTERNAL DIMENSION – VP DOME Window Size 0.1 in. (2.5mm thick), impact-resistant P.C (LEXAN) 3.93 in. (10cm) diameter Cable Entry One 1" (25mm

EXTERNAL DIMENSION – INDOOR DOME Window Size 0.1 in. (2.5mm thick), impact-resistant P.C (LEXAN) 3.93 in. (10cm) diameter Cable Entry One

SPECIFICATIONS (WDR) ITEM NTSC PAL ELECTRICAL Input Voltage DUAL(DC12V, AC24V) ±10% Power Consumption IR Off: 3.5 Watts(300mA) / IR On:6.0 Watts

SPECIFICATIONS (WDR-Lite) ITEM NTSC PAL ELECTRICAL Input Voltage DUAL(DC12V, AC24V) ±10% Power Consumption IR Off: 3.5 Watts(300mA) / IR On:6.0

MEMO 27

MEMO 28

MEMO 29

WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. DO NOT INSERT ANY METALLIC OBJECTS THROUGH THE

50303195A 30

FCC COMPIANCE STATEMENT FCC INFORMATION : This equipment has been tested and found to comply with the limits for a Class A digital device, p

IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do no

PRECAUTIONS Before installation, carefully read the manual to ensure correct operation and setup, heeding all warnings and instructions. Do not block

TABLE OF CONTENTS CONTENTS OF PACKAGE ------------------------------------------------------------------------- 7 INTRODUCTION -----------------------

INTRODUCTION The camera provided high-quality image using SONY 1/3” CCD and digital signal processing LSIs. Features:  1/3" Super-HAD CCD 

CAMERA CONNECTIONS Connection Cable Description COLOR Description RED AC24V/DC12V WHITE AC24V/DC12V BLUE RS485(-) GREEN RS485(+) YELLOW ALARM OUT G